Open Access
Issue
Oil & Gas Science and Technology - Rev. IFP
Volume 59, Number 6, November-December 2004
Dossier: Which Fuels for Low-CO2 Engines?
Page(s) 593 - 609
DOI https://doi.org/10.2516/ogst:2004043
Published online 01 December 2006
  • Abraham, J.,Bracco, F.V. and Reitz, R. D. (1985) Comparison of Computed and Measured Premixed Charge Engine Combustion. Combust. Flame, 60, 309. [CrossRef]
  • Béard, P., Colin, O. and Miche, M. (2003) Improved Modelling of DI Diesel Engines Using Sub-grid Descriptions of Spray and Combustion. SAE Paper 2003-01-0008.
  • Bilger, R.W. (1993) Conditional Moment Closure for Turbulent Reacting Flow. Phys. Fluids, A 5, 2, 436.
  • Bohbot, J., Zolver, M., Klahr, D. and Torres, A. (2003) Three Dimensional Modelling of Combustion in a Direct Injection Diesel Engine Using a New Unstructured Parallel Solver. Simulation and Modeling, in Computational Science and Its Applications - ICCSA 2003, Springer-Verlag, Berlin Heidelberg.
  • Boudier, P., Henriot, S., Poinsot, T. and Baritaud, T. (1992) A Model for Turbulent Flame Ignition and Propagation in Piston Engines. 24th Symposium (International) on Combustion, The Combustion Institute.
  • Candel, S. and Poinsot, T. (1990) Flame Stretch and the Balance Equation for the Flame Area. Combustion Science and Technology, 70, 1-15. [CrossRef]
  • Chalak, Z. (1990) Modélisation du délai d'auto-inflammation dans un moteur Diesel ; validation expérimentale. PhD Thesis, Rouen University.
  • Chen, C., Bardsley, M. and Johns, R. (2000) Two-Zone Flamelet Combustion Model. SAE Paper 2000-01-2810.
  • Colin, O,Benkenida, A. and Angelberger, C. (2003) A 3D Modeling of Mixing, Ignition and Combustion Phenomena in Highly Stratified Gasoline Engines. Oil & Gas Science and Technology, Rev. IFP, 58, 1, 47-62. [CrossRef] [EDP Sciences]
  • Colin, O., Pires da Cruz, A. and Jay, S. (2004) Detailed Chemistry Based Auto-Ignition Model Including Low Temperature Phenomena Applied to 3D Engine Calculations. 30th Symposium (International) on Combustion, Pittsburgh, The Combustion Institute, 2649-2656.
  • Curran, H.J.,Gaffuri, P.,Pitz, W.J. and Westbrook, C.K. (1998) A Comprehensive Modeling Study of n-Heptane Oxidation. Combust. Flame, 114, 149. [CrossRef]
  • Dec, J.E. (2002) A Computational Study of the Effects of Low Fuel Loading and EGR on Heat Release Rates and Combustion Limits in HCCI Engines. SAE Paper 2002-01-1309.
  • Docquier, N. (2003) Experimental Investigations in an Optical HCCI Diesel Engine. About the Influence of Fresh Charge Preparation and Composition on Auto-Ignition Delays and Combustion Development. 19th International Colloquium on the Dynamics of Explosions and Reactive Systems, Hakone, Japan, 27 July-1 August.
  • Duclos, J.M., Bruneaux, G. and Baritaud, T. (1996) 3D Modelling of Combustion and Pollutants in a 4Valve SI Engine: Effect of Fuel and Residuals Distribution and Spark Location. SAE Paper 961964.
  • Duclos, J.M. and Colin, O. (2001) Arc and Kernel Tracking Ignition Model for 3D Spark-Ignition Engine Calculation. International Symposium COMODIA.
  • Duclos, J.M. and Zolver, M. (1998) 3D Modeling of Intake, Injection and Combustion in a DI-SI Engine under Homogeneous and Stratified Operating Conditions. International Symposium COMODIA.
  • Gicquel, O., Darabiha, N. and Thévenin, D. (2000) Laminar Premixed Hydrogen/Air Counterflow Flame Simulations Using Flame Prolongation of ILDM with Differential Diffusion. 28st Symposium (International) on Combustion, Pittsburgh, The Combustion Institute.
  • Hasse, C., Bikas, G. and Peters, N. (2000) Modeling DI Diesel Combustion using the Eulerian Particle Flamelet Model (EPFM). SAE Paper 2000-01-2934.
  • Henriot, S., Bouyssounnouse, D. and Baritaud, T. (2003) Port Fuel Injection and Combustion Simulation of a Racing Engine. SAE Paper 2003-01-1845.
  • Heywood, J.B. (1988) Pollutant Formation and Control. In: Internal Combustion Engine Fundamentals, McGraw-Hill, Inc.
  • Kleemann, A.P., Menegazzi, P., Henriot, S. and Marchal, A. (2003) Numerical Study on Knock and SI Engine by Thermally Coupling Combustion Chamber and Cooling Circuit Simulations. SAE Paper 2003-01-0563.
  • Klimenko, A. and Yu, (1990) Multicomponent Diffusion of Various Admixtures in Turbulent Flow. Fluid Dynamics, 25, 327.
  • Kong, S.C., Han, Z. and Reitz, R.D. (1995) The Development and Application of a Diesel Ignition and Combustion Model for Multidimensional Engine Simulation. SAE Paper 950278.
  • Lafossas, F.A., Castagne, M., Dumas, J.P. and Henriot, S. (2002) Development and Validation of a Knock Model in Spark Ignition Engines Using a CFD Code. SAE Paper 2002-01-2701.
  • Marble, F.E. and Broadwell, J.E. (1977) The Coherent Flame Model of Non-Premixed Turbulent Combustion. Projet Squid TRW-9-PU, Projet Squids Headquarters, Chaffee Hall, Purdue University.
  • Martinot, S., Béard, P. and Roesler, J. (2001) Comparison and Coupling of Homogeneous Reactor and Flamelet Library Soot Modeling Approaches for Diesel Combustion. SAE Paper 2001-01-3684.
  • Peters, N. (1986) Laminar Flamelet Concepts in Turbulent Combustion. 21st Symposium (International) on Combustion, Pittsburgh, The Combustion Institute.
  • Pitsch, H., Wan, Y.P. and Peters N. (1995) Numerical Investigation of Soot Formation and Oxidation under Diesel Engine Conditions. SAE Paper 952357.
  • Pitsch, H., Chen, M. and Peters, N. (1998) Unsteady Flamelet Modeling of Turbulent Hydrogen-Air Diffusion Flames. 27th Symposium (International) on Combustion, Pittsburgh, The Combustion Institute.
  • Réveillé, B., Miche, M., Jay, S. and Henriot, S. (2004) Contribution of 3D CFD Tools to the Development and Understanding of Diesel Engines: Improving Today’s Engines and Designing Tomorrow’s Poser Units. SIA, Le Diesel : aujourd’hui et demain, École centrale de Lyon, 12-13th May.
  • Tap, F.A., Hilbert, R., Thévenin, D. and Veynante D. (2004) A Generalized Flame Surface Density Modelling Approach for the Auto-Ignition of a Turbulent Non-Premixed System. Combust. Theory Modelling, 8, 1, 163-193. [CrossRef]
  • Van Kalmthout, E., Veynante, D. and Candel, S. (1996) Direct Numerical Simulation Analysis of Flame Surface Density Equation in Non-premixed Turbulent Combustion. 26th Symposium (International) on Combustion, Pittsburgh, The Combustion Institute.
  • Vervish, L.,Hauguel, R.,Domingo, P. and Rullaud, M. (2004) Three Facets of Turbulent Combustion Modelling: DNS of Premixed V-flame, LES of lifted nonpremixed flame and RANS of jet-flame. Journal of Turbulence, 5, 004.
  • Veynante, D. and Vervisch, L. (2002) Turbulent Combustion Modeling. Progress in Energy and Combustion Science, 28, 93-266. [CrossRef]
  • Zhang et al. (2004) Multidimensional HCCI Modeling Using Complex Chemistry and Transported pdf’s. 30th Symposium (International) on Combustion, Pittsburgh, The Combustion Institute.
  • Zolver, M., Benkenida, A., Bohbot, J., Klahr, D. and Réveillé. B. (2004) CFD Tools at IFP for HCCI Engine Simulations. 14th International Multidimensional Engine Modeling User’s Group Meeting at the SAE Congress, Detroit, Michigan, 7 March.
  • Zolver, M., Bohbot, J., Klahr, D. and Torres, A. (2004) An Unstructured Parallel Solver for Multi-Phase and Reactive Flows in Internal Combustion Engines. Combustion Problems. In: Parallel Computational Fluid Dynamics, Elsevier BV, Amsterdam.
  • Zolver, M.,Klahr, D.,Bohbot, J.,Laget, O. and Torres, A. (2003) Reactive CFD in Engines with New Unstructured Parallel Solver. Oil & Gas Science and Technology, Rev. IFP, 58, 1, 33-46. [CrossRef] [EDP Sciences]

Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.

Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.

Initial download of the metrics may take a while.