Statistical estimation of frictional coefficients of faults based on a structural dataset in the Tuy Hoa–Vung Tau Region, Viet Nam
South-Vietnam Geological Mapping Division, 200 Ly Chinh Thang Street, Ward 9, District 3, Ho Chi Minh City 700000, Vietnam
2 Faculty of Geology and Petroleum Engineering, Ho Chi Minh University of Technology (HCMUT), 268 Ly Thuong Kiet Street, District 10, Ho Chi Minh City 700000, Vietnam
3 Vietnam National University Ho Chi Minh City, Linh Trung Ward, Thu Duc District, Ho Chi Minh City 700000, Vietnam
4 PetroVietnam University, 762 Cach Mang Thang Tam Street, Long Toan Ward, Ba Ria City, Ba Ria – Vung Tau Province 790000, Vietnam
5 Department of Petroleum Engineering, Universitas Islam Riau, Jl. Kaharuddin Nasution 113, Pekanbaru Riau 28284, Indonesia
6 Faculty of Geology, University of Science, 227 Nguyen Van Cu Street, District 5, Ho Chi Minh City, 700000, Vietnam
* Corresponding author: email@example.com
Accepted: 18 March 2021
This study estimates the shear friction coefficient from shear friction angles for the prediction of slip tendencies in the Tuy Hoa–Vung Tau region of Southern Vietnam. A dataset consisting of measured data of 355 fractured planes, striations, and unconformities in coastal areas as well as 239 offshore faults was analyzed based on the principles of statistical probability. As a result, 138 friction angles for the onshore and offshore faults were calculated based on shear fracture conjugate pairs. The goodness-of-fit test was used to define the probability distribution of the friction angles, which had a normal distribution. The acceptable average of friction angles for the onshore region with a reliability of more than 95% were in the range of 25.8–31.5°, which corresponds to frictional coefficients of 0.48–0.61. The acceptable average friction angles for the offshore region were relatively low at 23–31°, which corresponds to a frictional coefficient of 0.42–0.60. Owing to the heterogeneity of the fault system, the median value (19.12°) should be used as the lowest threshold value for slipping faults at all conditions. The recommended applicable average friction angles are 28.65° and 27° for the onshore and offshore regions, respectively. The estimation of the frictional coefficients is highly reliable, and it can be applied to other subsurface resource exploitation projects within the study area.
© D. Linh et al., published by IFP Energies nouvelles, 2021
This is an Open Access article distributed under the terms of the Creative Commons Attribution License (https://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.