Open Access
Issue
Oil & Gas Science and Technology - Rev. IFP Energies nouvelles
Volume 73, 2018
Article Number 33
Number of page(s) 7
DOI https://doi.org/10.2516/ogst/2018029
Published online 25 September 2018
  • Aluhwal H., Kalifa O. (2008) Simulation study of improving oil recovery by polymer flooding in a Malaysian reservoir, Master’s Thesis, Faculty of Chemical and Natural Resources Engineering, Universiti Teknologi Malaysia. [Google Scholar]
  • Bondor P.L., Hirasaki G.J., Tham M.J. (1972) Mathematical simulation of polymer flooding in complex reservoirs, SPE J. 12, 5, 369–382. [Google Scholar]
  • Brooks R.H., Corey A.T. (1966) Properties of porous media affecting fluid flow, J. Irrig. Drain. Div. 6, 61. [Google Scholar]
  • Cheng J., Wei J., Song K., Han P. (2010) Study on remaining oil distribution after polymer flooding, in SPE Annual Technical Conference and Exhibition, Florence, Italy, September 19–22. [Google Scholar]
  • Dai C., You Q., Wang Y., Zhao F., Shuler P. (2010) Research on reutilization technology of residual polymer in formation after polymer flooding, in SPE Improved Oil Recovery Symposium Tulsa, OK, USA, April 24–28. [Google Scholar]
  • Falode O.A., Afolabi F.A. (2011) Simulation study of polymer flooding performance: effect of clay minerals, Petrol. Coal 53, 3, 206–211. [Google Scholar]
  • Hou Q., Zhu Y., Luo Y., Weng R. (2012) Studies on foam flooding EOR technique for Daqing Reservoirs after polymer flooding, in SPE Improved Oil Recovery Symposium, Tulsa, OK, USA, April, 14–18. [Google Scholar]
  • Jamaloei B.Y., Kharrat R., Asghari K. (2012) The influence of salinity on the viscous instability in viscous-modified low-interfacial tension flow during surfactant-polymer flooding in heavy oil reservoirs, Fuel 97, 174–185. [CrossRef] [Google Scholar]
  • Kazemi H., Merrill L.S. Jr, Porterfield K.L., Zeman P.R. (1976) Numerical simulation of water-oil flow in naturally fractured reservoirs, SPE J. 16, 6, 317–326. [Google Scholar]
  • Kou X., Li Z., Wang R., Guo L. (2010) The study of the impact of capillary pressure curve on numerical simulation of gas field, OGSE 29, 9, 31–33 [in Chinese]. [Google Scholar]
  • Jennings R.R., Rogers J.H., West T.J. (1971) Factors influencing mobility control by polymer solutions, J. Petrol. Technol. 23, 3, 391–401. [CrossRef] [Google Scholar]
  • Lenormand R., Li K., Robin M., Codreanu D.B. (1997) Numerical evaluation of the combined effect of wettability and heterogeneity on waterflood performance, in Proc. of the 9th European Symposium on Improved Oil recovery, EAGE, The Hague, The Netherlands, October, 20–22. [Google Scholar]
  • Li K., Firoozabadi A. (2000) Experimental study of wettability alteration to preferential gas-wetting in porous media and its effects, SPE Reserv. Eval. Eng. 3, 2, 139–149. [Google Scholar]
  • Li K., Horne R.N. (2005) Computation of capillary pressure and global mobility from spontaneous water imbibition into oil-saturated rock, SPE J. 10, 4, 458–465. [CrossRef] [Google Scholar]
  • Li K., Horne R.N. (2006) Comparison of methods to calculate relative permeability from capillary pressure in consolidated water-wet porous media, Water Resour. Res. 42, W06405. [Google Scholar]
  • Li K., Liu Y. (2011) Enhanced gas-condensate production by wettability alteration to gas wetness, J. Petrol. Sci. Eng. 78, 505–509. [CrossRef] [Google Scholar]
  • Li K., Sun W., Li F., Qu Y., Yang Y. (2014) Novel method for characterizing single-phase polymer flooding, SPE J., 19, 19, 695–702, https://doi.org/10.2118/152988-PA. [CrossRef] [Google Scholar]
  • Liu H., Li G. (2011) An enhanced oil recovery technology continually after polymer-flooding, in SPE Enhanced Oil Recovery Conference, Kuala Lumpur, Malaysia, July 19–21. [Google Scholar]
  • Liu Y., Zheng H., Huang G., Li G., Li K. (2006) Improving production in gas-condensate reservoirs by wettability alteration to gas wetness, in Presented at the 2006 SPE/DOE Symposium on Improved Oil Recovery, Tulsa, OK, USA, April 22–26, SPE 99739. [Google Scholar]
  • Ma D., Dong M., Si Z., Han C., Zhang L., Zeng M. (2011) Experimental study on enhanced oil recovery with wettability alteration to gas wetness, Fault-Block Oil and Gas Field 18, 3, 386–388 [in Chinese]. [Google Scholar]
  • Masalmeh S.K. (2003) The effect of wettability heterogeneity on capillary pressure and relative permeability, J. Petrol. Sci. Eng. 39, 3–4, 399–408. [CrossRef] [Google Scholar]
  • Murata T. (1981) Wettability of coal estimated from the contact angle, Fuel 60, 8, 744–746. [CrossRef] [Google Scholar]
  • Needham R.B., Doe P.H. (1987) Polymer flooding review, J. Petrol. Technol. 39, 12, 1503–1507. [CrossRef] [Google Scholar]
  • Paul G.W., Lake L.W., Pope G.A., Young G.B. (1982) A simplified predictive model for micellar-polymer flooding, in SPE California Regional Meeting, San Francisco, CA, USA, March 24–26. [Google Scholar]
  • Purcell W.R. (1949) Capillary pressures – Their measurement using mercury and the calculation of permeability, Trans. AIME 186, 39. [Google Scholar]
  • Qiao W., Li J., Zhu Y., Cai H. (2012) Interfacial tension behavior of double long-chain 1,3,5-triazine surfactants for enhanced oil recovery, Fuel 96, 220–225. [CrossRef] [Google Scholar]
  • Ren X., Liu B., Li Y. (2008) Application of wettability reversal agent in low permeability and bottom water oil reservoir, Fault-Block Oil and Gas Field 15, 5, 72–74 [in Chinese]. [Google Scholar]
  • Su H., Wu X., Li W. (2010) The effect of change of reservoir wettability on oil recovery, Petrol. Drill. Tech. 38, 6, 92–94. [Google Scholar]
  • Valavanides M.S. (2018) Oil fragmentation, interfacial surface transport and flow structure maps for two-phase flow in model pore networks. Predictions based on extensive, DeProF model simulations, Oil Gas Sci. Technol. - Rev. IFP Energies nouvelles 73, 6. [CrossRef] [Google Scholar]
  • Wang D., Cheng J., Wu J., Wang G. (2002) Experiences learned after production of more than 300 million barrels of oil by polymer flooding in Daqing Oil Field, in SPE Annual Technical Conference and Exhibition, San Antonio, TX, USA, September 29–October 2. [Google Scholar]
  • Verga F., Lombardi M., Maddinelli G., et al. (2017) Introducing core-shell technology for conformance control, Oil Gas Sci. Technol. - Rev. IFP Energies nouvelles 72, 1, 5. [CrossRef] [Google Scholar]
  • Xie C., Guan Z., Blunt M., Zhou H. (2009) Numerical simulation of oil recovery after cross-linked polymer flooding, J. Can. Petrol. Technol. 48, 4, 37–41. [CrossRef] [Google Scholar]
  • Zhang P., Tweheyo M.T., Austad T. (2006) Wettability alteration and improved oil recovery in chalk: the effect of calcium in the presence of sulfate, Energy Fuels 20, 5, 2056–2062. [CrossRef] [Google Scholar]
  • Zhang P., Wang Y., Yang Y., et al. (2015) Effective viscosity in porous media and applicable limitations for polymer flooding of an associative polymer, Oil Gas Sci. Technol. - Rev. IFP Energies nouvelles 70, 6, 931–939. [CrossRef] [Google Scholar]

Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.

Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.

Initial download of the metrics may take a while.